Hi Folks,
Just don't see what I'm doing wrong.
I have 8 new 600GB drives that I have installed into my IBM 7383 M4.
Entered 4 groups, RAID10
When I try to save the configuration Yes/No, I select Yes but nothing happens!.
I waited about 5 minutes no change. When I exit back to the Dashboard view,,, it shows...
Drives 0
Drive Groups 0
Virtual Drives 0
It's been a while since I have done one of these but don't remember having this much trouble.
Do I need to run Ctrl-H or Ctrl-S and set it up there first?
Thanks for your input!
Jim